Installation, local to Cleburne
We make it, and near Cleburne we hang it too.
Installation is a separate service from the materials we ship. Our own crew installs the gutters, downspouts and collector heads we fabricate, on homes within driving distance of the shop.
In short
Everything we install is fabricated in our shop first, so the pieces that arrive at your house were made for it: the gutter runs, the miters for your corners, the outlets for your downspouts and the hangers for your fascia.
Installation is only offered near Cleburne. If you are further away, we ship the full set of materials to you or your contractor, with every piece labelled for the run it belongs to.
What installation includes
What our crew does on site
Four parts to every installation job.
A site measure
We measure every run, note the corners and drops, and check the fascia and roof edge before anything is fabricated.
Fabrication to the measure
Gutter, miters, outlets and heads are made in the shop for your dimensions, not cut from stock on the driveway.
Hanging and soldering
Runs are set to fall toward the outlets, hung on hangers matched to the profile, and the joints are soldered.
Water test and walk-through
We run water through every outlet, check the drops and walk the job with you before we leave.
How it works
From quote to finished runs
Five steps, and you know which one you are in.
Step 1
Build an estimate or send a message
Use the configurator with your rough linear feet, or just tell us about the house. Add your ZIP code so we can confirm the address is inside our installation area.
Step 2
Site measure
We visit, measure the runs and talk through profile, size and where the downspouts should go.
Step 3
Written quote
You get a quote that lists materials and installation as separate lines, with a lead time.
Step 4
Fabrication
Your pieces are made in the shop, soldered and checked.
Step 5
Installation day
The crew hangs the runs, sets the downspouts, tests with water and clears the site.
What we install
Pieces we install
All fabricated in our Cleburne shop.
- Half-round and K-style copper gutter in 5, 6 and 7 inch
- Round and rectangular copper downspouts with elbows
- Collector heads and conductor heads
- End caps, miters, outlets and hangers
- Copper gutter guards
- Chimney caps, finials, louvers and dormers from our custom work
Materials and installation
Shipped anywhere, installed nearby
Materials are fabricated in Cleburne and shipped to any state. Installation is a separate, local service for addresses near Cleburne, Texas, confirmed by ZIP code when you request a quote.
Installation questions
Common questions about installation
Around Cleburne, Texas. Enter your ZIP code in the configurator or send it with your message and we will confirm whether your address is inside our installation area. Outside it, we ship the materials to you.
Yes. That is how most orders outside the Cleburne area work. We fabricate the full set to your measurements, label each piece and ship it to you or to your contractor.
No. The configurator shows materials. When you choose materials plus installation, installation is listed as its own line and confirmed for your address with the written quote.
Ask when you request a quote. Tell us what is on the house now and we will include removal in the installation quote where we can.
Ready for copper on your house?
Start with the configurator or send us the address and a few photos.